Teach you how to repair toilet lid damper

Newly bought toilet lid, close the toilet lid, the lid and cushion will slowly fall down, slow speed. However, for a long-term toilet, the lid always falls off quickly and collides violently with the toilet seat. What caused the difference? The culprit was a broken toilet lid damper. Next I'll tell you how to repair the toilet lid damper.

1. toilet lid damper is broken How to repair the principle of slow damping?

The principle of cushioning the toilet lid is a cushioning system, which consists of an inner cylinder, an outer cylinder and damping oil sealed in the cylinder. There is a rotating shaft in the middle, which is spiral, with a large hole at one end and a small hole at the other end. When the toilet lid falls, it will drive the shaft to rotate, and the oil in the toilet lid damper is pressed from the large hole to the small hole by the screw. Because the hole is small, it will be discharged slowly, so as to realize the slow release function of the toilet lid.

How to remove the baffle of the 2. toilet seat?

Toilet lid damping helps to reduce the resonance amplitude of the mechanical structure, so as to avoid damage to the structure due to vibration stress reaching the limit. Damping helps the mechanical system to quickly return to a stable state after an instantaneous impact. As for how to remove the shock absorber of the toilet lid, the specific methods are as follows:

1. First, find two small holes inside the toilet lid with nuts below. Then loosen the nut and remove the toilet lid. In order to facilitate the tightening of the screws, it is recommended to use a hexagonal wrench.

2. The toilet lid damper is attached to the toilet lid. There is no difference in the size of the toilet lid, only two bolts need to be adjusted during installation. If the toilet lid does not need to be replaced, tighten it with a wrench; if it needs to be replaced, the toilet lid and the rear pin should be replaced and installed together.

3. How to repair the toilet lid damper is very slow?

The reason why the toilet lid is no longer slowly put down is that the sealing is not good, and the damping of the oil leakage is not enough, so it is difficult to repair and can only be replaced. The specific operation is to remove the original toilet shock absorber. The pins at both ends of the connection between the toilet cover and the toilet are the shock absorption and lowering system of the toilet cover. Press the inside of the pin outward with a tool and lift and remove the toilet lid. Measure and observe the size and style of the detached pin, and then purchase the same type of pin according to the sample. Then, install a new damper, reverse the operation according to the disassembly method, install the newly bought pin on the toilet lid, and then align the two holes on the pin with the column on the toilet, and press-fit it.

Have you learned all the little knowledge about how to repair the toilet lid when the toilet lid damper is lowered slowly? It is not difficult for those who can't, and it is not difficult for those who can. Try it yourself.

What is the reason why the 3. toilet baffle is not buffered?

1. The toilet lid damper cannot be buffered, usually caused by loose screws. You can loosen the back of the toilet and the toilet lid connected to the fastening screw, adjust the position of the toilet lid, fixed. If it is still not buffered, find the nut of the toilet lid, remove the nut, remove the lid, remove the dirt and burrs on the toilet, clean it, and put the toilet lid back. If these two methods do not work, it is recommended to replace the shock absorber.

2. The toilet lid damper is installed on the top of the toilet and is an accessory device of the toilet. It has the function of isolating bacteria. However, ordinary toilet seats have very tiny microbes that are invisible to the naked eye.