News

Home

toilet lid damper maintenance methods?

Release time:

2022-07-25 11:41

Source:

Consumers should pay attention to the choice of drawers when choosing furniture products, such as some cabinets or bookcases. The drawer is very important is its slide, because the slide is the whole soul. If the slide rail is good, the quality of the whole drawer can be guaranteed. Then, what are the maintenance methods for the toilet lid damper?

What are the maintenance methods for the toilet lid damper?

1. The spring damping shock absorbers delivered to the site should be stacked neatly, and the spring damping shock absorbers should not be stepped on.

2. The shock absorber should be covered and maintained to prevent premature aging due to wind and rain.

3. The cutting spring shock absorber should be straight, not angled.

4. Shock absorber method: The shock absorber should be wrapped with a large spring shock absorber with a length of 0.3m, with half tight ends and no gap in the middle. To ensure that there is no gap between them, the ends of the two connectors should be marked. Tape tightly to prevent leakage.

5. The position of the shock absorber should be accurate, especially near the joints. The spacing between the positioning reinforcement of the spring damper is 0.5m, which is not short.

6. When the welded steel bar is close to the spring damper, measures should be taken to ensure that the spring damper is not damaged by

. If you are accidentally scalded, please use tape to tightly enclose the scalded area . 7. Considering that the number of spring damping dampers on the roof is gradually decreasing, spring damping dampers should be avoided in all places that conflict with spring damping dampers.

8. When pouring concrete, the material should not lean on the spring damping shock absorber. The vibrator will not collide with the spring shock absorber. It is forbidden to clamp the two vibrators with the spring-damping vibrator. Especially when vibrating the network, it is forbidden to vibrate in the same direction for a long time, and the vibration time is less than 20 seconds.

9. When taking out the mold, pay attention to prevent the spring shock absorber from leaking. These points require our attention. These problems can be prevented by paying attention to these details and paying attention to them. If the above problems cause damage to the spring damping shock absorber, it should be replaced immediately, and construction is not allowed to avoid loss.

What are the toilet lid damper cleaning?

1. Check whether the dust is inside the slide rail or inside the damper. If it is inside the slide rail, just wipe it with a cloth. If it is inside the damper, the normal damper design is closed and dust cannot enter the damper, so it doesn't matter.

2, is made of high purity inorganic thickener and synthetic oil with a variety of additives. Non-toxic, in line with environmental regulations. Sealed and waterproof. It is used to connect parts, allowing larger gaps and tolerances, and has a buffer function to make the parts move smoothly and accurately.

3. If too much damping grease is added, it will increase the running resistance of the internal parts of the engine and cause unnecessary power loss. Moreover, too much shock-absorbing grease will escape into the combustion chamber, causing the engine to burn oil, excessive exhaust emissions, blue smoke, and a significant increase in fuel consumption, resulting in increased carbon deposits inside the engine, even premature combustion, burning out, and cylinder pulling. Will damage the engine.

what are the advantages of toilet lid damper?

toilet lid damper need to pay attention to what matters?