News

Home

toilet lid damper installation method?

Release time:

2023-02-09 10:17

Source:

When it comes to toilet lid dampers, I believe many people don't know much about them. Not to mention knowing how to replace it. But don't worry, the following I will address this question, to give you a brief introduction of the toilet lid damper installation method? I hope it can help more people.

When replacing the toilet lid damper, the original one must be removed first, and then the toilet lid damper can be seen from both ends. At this time, the comb inside is pressed outward so that the toilet lid can be removed. Note that tools are needed here, it is easy to hurt your hands. Then be sure to measure and observe the removed pins to see what size and style they are, and then buy pins of the same model. This can be installed with a new one, according to how to disassemble and how to install it back, then install the newly bought pin on the toilet lid, align the pin there with the two holes on the toilet column, and press it to install it. So is it a one-off? This is a problem that everyone is more concerned about. In fact, it can be used for a long time. The key is to buffer the toilet cover when it falls into contact with the toilet to prevent the sound from being too loud. If the valve is broken, replace it directly. First of all, the original toilet damper is removed, generally located at the connection between the upper cover and the barrel. We can directly use the tool to remove the pins on both sides. Then buy 2 pins of the same model according to the size and style of the old pin. Follow the toilet damper removal method and reinstall the one you just purchased.

Long-term opening and closing of the toilet lid damper will seriously damage the toilet and toilet lid, seriously affect the service life, and can only be gently put down. To change that, rotation is key. When you use it, you should know that the special cushioning function of the toilet damper can improve the slow mechanical movement process when the lid is lowered, thereby providing a slow and rhythmic descent, thereby preventing the gravity generated by the inertial descent, thereby reducing noise interference, Extend service life. In short, the toilet lid damper needs to be replaced by removing the rear mounting bolts, and the installation can be operated in the opposite direction. Generally, there is no difference in size. You can adjust the two bolts during installation, but you also need to measure the size, screw hole distance, width and length of the toilet seat. Next, you need to find the position of the nut, and then select the appropriate wrench to remove the nut. The position of the toilet lid is divided into light color and dark color. The bright parts are easy to find, while the dark screws. The hood is hard to find. The toilet lid damper is usually placed on the edge of the tank. You must open the lid, reach in, and feel the nut in the direction of the water tank.

After the introduction of the above content, we also have a further understanding of the installation method of the toilet lid damper. When I see him again in the future, I will not feel strange, and there will be no frequent problems in the process of using it. Well, that's all for today's content. I believe it will bring more wonderful knowledge points.

马桶盖阻尼器